This is a section to view these data in VIEW and REPORT in DIAdem
You can change the length of data in Y-Axis, but X-Axis is impossible in VIEW.
In the Report, you can change these things.
1. Setting the VIEW screen
So at first, I will guide how to set VIEW.
The representation of data as shown below in the 2D Axis VIEW.
If you double-click in the chart area 2D Axis System – Display Scaling window is opened. You can insert what you want to see manually.
The below figure is the value specified by the Begin -6, End 6.
Next, let's create a four quadrant (Quadrant Chart) REPORT on the screen.
2. Setting REPORT on the screen
REPORT also adds the Simple 2D Axis System in the following way.
Drag the data to the 2D Axis System to the configuration as shown below.
Double-click the chart to bring up the Curve And Axis Definition window.
In this window you can set aside Scaling to go to Axis Parameter X and Y axes.
X, respectively, to change the Scalimg Mode to Manual with respect to the Y axis, and modify the Begin and End values.
[X-axis changes Results]
Since the start value and the end value is 0.035, 0.035, 0.046 Begin also - as was (0.035, 0.046) = 0.025.
[Y axes to change the results]
If the above changes to the same set of 2D Axis System REPORT will be changed as follows.
Finally, select the Y-axis, and drag, you can move to the middle.
How to create a chart with four quadrants in DIAdem not that difficult.
Thanks.
